PeopleWith

Book a discovery call

PeopleWith

Guide · Participant recruitment

How to recruit patients through GP practices in the UK

How to recruit patients through GP practices in the UK

How to recruit patients through GP practices in the UK

A step-by-step guide for research teams: approvals, practice roles, finding and inviting eligible patients, eConsent, and keeping participants in your study.

Last reviewed November 2026 · 8-minute read

GP practicesEligible patientsHealth recordsStudy sitesGOVERNANCE · PEOPLE · DATARecruitmentDigital consentStudy delivery
GP practicesEligible patientsHealth recordsStudy sitesGOVERNANCE · PEOPLE · DATARecruitmentDigital consentStudy delivery

31

sites recruiting within 35 days in IID3

1,400

participants recruited within 5 weeks of approval

9,000

recruited and retained within 7 months

<1%

attrition, down from an initial 45% estimate

The short answer

Plan it in early, keep practice workload light, and keep participants engaged.

Plan it in early, keep practice workload light, and keep participants engaged.

To recruit patients through GP practices in the UK, build recruitment into your protocol and budget from the start, get HRA and ethics approval, and decide whether practices will act as participant identification centres or full research sites. Then activate practices with as little extra work for their staff as possible. Each practice searches its own clinical system for eligible patients and invites them. Patients consent, ideally digitally, and you keep them engaged until the study ends. The hard part is rarely finding eligible patients. It's usually one of these:

Recruitment targets

Only 56% of NIHR HTA trials hit their final recruitment target

32% needed an extension. Source: Walters et al., BMJ Open (2017), review of 151 trials.

Practice capacity

85.7% of primary care staff say they can't fit anything extra in

Source: PLOS One (2025), survey of primary care staff.

Retention

Participants drift away

Every participant lost after recruitment has to be replaced, which costs time and money and weakens the evidence.

Watch the 8 steps in under 2 minutes, or read the full guide below.

Step-by-step guide

Eight steps to recruiting through GP practices.

Eight steps to recruiting through GP practices.

Step 1

Build recruitment into the protocol and budget

Decide early how participants will be found, invited and consented, and how many practices you'll need, and write it into the protocol and application. Funding bodies look closely at whether recruitment plans are realistic, so show your method, expected numbers and how you'll keep people in the study. Use SoECAT to attribute costs correctly, and name any platform you'll use for recruitment and data capture in your data management plan.

Step 2

Get the approvals

Most NHS research needs HRA approval and a favourable opinion from a Research Ethics Committee. Your documents should describe exactly how practices will identify and contact patients, what patients will receive, and how consent will be taken. If the study uses identifiable information without consent, for example to screen records centrally, you may also need Confidentiality Advisory Group support in England and Wales. Scotland and Northern Ireland have their own routes.

Step 3

Decide the role of each practice

Practices usually take part as a participant identification centre (PIC), which searches its records, checks the list and invites eligible patients before the study team takes over, or as a full research site that also takes consent and carries out study activities. PIC roles ask much less of practice staff, so more practices can take part. The NIHR Research Delivery Network can help you find research-ready practices in each region.

Step 4

Activate practices without adding to their workload

Brief practice teams in plain language and train them remotely, so no one gives up clinic time for set-up visits. Give each practice a clear, short list of what it needs to do, and automate everything else. The less a practice has to do by hand, the faster it starts recruiting and the longer it keeps going.

Step 5

Identify eligible patients

Eligible patients are found by searching the practice's clinical system (EMIS, TPP SystmOne or Vision) against the study's inclusion and exclusion criteria. A GP then usually reviews the list to remove anyone it wouldn't be appropriate to contact. Systems connected through the NHS IM1 interface let approved suppliers run the same searches consistently across many practices, rather than each practice building its own.

Step 6

Invite patients and capture consent

Invitations normally come from the patient's own practice, by letter, text or email, because the practice already holds the relationship and the data. Researchers shouldn't receive identifiable details until the patient has responded or consented, unless there's another approved legal basis. Electronic consent (eConsent) lets patients read the information and consent remotely, and records exactly what each person agreed to and when.

Step 7

Keep participants in the study

Recruitment is only half the job. Participants who drop out have to be replaced, which costs time and money and weakens the results. What keeps people involved: making participation easy, for example through an app that also helps them manage their own health; regular reminders and contact; support when they have questions; and telling participants what the study has found.

Step 8

Track recruitment as it happens

Watch recruitment by practice and by week, not just in monthly totals. Near-real-time dashboards show which practices are slow, where invitations aren't converting and where participants are dropping out, so you can act while there's still time to recover.

Finding eligible patients

Searches run on the practice's own clinical system.

Searches run on the practice's own clinical system.

Most GP practices in England use one of three clinical systems. Running the same search criteria across all of them gives you consistent lists of eligible patients.

System

EMIS

One of the main GP clinical systems used across UK practices.

System

TPP SystmOne

One of the main GP clinical systems used across UK practices.

System

Vision

A GP clinical system used by a smaller share of practices.

Interface

IM1

The NHS interface that lets approved suppliers work with GP systems, so searches can run consistently across practices.

What good looks like: IID3

From approval to 9,000 participants in 7 months.

From approval to 9,000 participants in 7 months.

In IID3, GP practices invited patients from their own clinical systems, and participants joined, consented and reported through PeopleWith. Recruitment was 298% faster than baseline, and cost 45% less than traditional methods (benchmarked using SoECAT and AcORD).

Day 35

31 sites

actively recruiting

Week 5

1,400

participants recruited

Month 7

9,000

recruited and retained

Throughout

<1%

attrition, down from an initial 45% estimate

Common mistakes

Six mistakes that slow GP recruitment.

Six mistakes that slow GP recruitment.

Treating recruitment as an afterthought. If the method and numbers aren't in the protocol and application, they're hard to change later.

Asking practices to do too much by hand. Every extra task slows activation and recruitment.

Letting each practice run its own search. Different searches produce inconsistent lists, so run the same criteria everywhere.

Paper-only consent. It adds delay, travel and transcription errors. eConsent is faster and leaves a complete record.

Forgetting retention. A study that recruits fast but loses participants has to recruit again.

Waiting for monthly reports. By the time a slow practice shows up in a monthly total, weeks have been lost.

Practice roles

A participant identification centre (PIC) searches its records, checks the list and invites eligible patients, then the study team takes over. A research site also takes consent and carries out study activities. PIC roles ask much less of practice staff, so more practices can take part.

Questions research teams ask

Frequently asked questions

Frequently asked questions

How do researchers recruit patients through GP practices?

Practices search their clinical systems for patients who meet the study criteria. A GP reviews the list, and the practice invites eligible patients by letter, text or email. Interested patients then consent and join the study, often digitally.

What approvals do I need to recruit through GP practices?

Most NHS studies need HRA approval and a favourable Research Ethics Committee opinion. These should describe how practices will identify and contact patients and how consent will be taken. Using identifiable information without consent may also need Confidentiality Advisory Group support in England and Wales.

What is a participant identification centre (PIC)?

A PIC is a practice that identifies and invites potential participants but doesn't carry out the study itself. It asks much less of practice staff than being a full research site.

Which GP systems can be searched for eligible patients?

The main GP clinical systems in the UK are EMIS, TPP SystmOne and Vision. Approved suppliers connected through the NHS IM1 interface can run consistent searches across practices using these systems.

Can patients consent remotely?

Yes. Electronic consent (eConsent) lets patients read the study information and consent online, and it records exactly what each person agreed to and when.

How do you keep participants in a primary care study?

Make taking part easy, keep in regular contact, offer support, and report back on what the study finds. In IID3, built-in patient support helped bring attrition from an initial 45% estimate to under 1%.

Can I name a recruitment platform in my funding application?

Yes. PeopleWith provides data management plan wording, a letter of support and a costed proposal, so you can name PeopleWith as your governed delivery platform in applications to NIHR, UKRI, MRC, Innovate UK and other funding bodies.

This guide is general information, not regulatory advice. Requirements depend on your study design, data sources and where in the UK it runs. Check the latest Health Research Authority guidance before you start. Sources: Walters et al., BMJ Open (2017); PLOS One (2025); IID3 figures from live PeopleWith delivery.

Planning a primary care study?

PeopleWith runs recruitment and study delivery for funded research.

PeopleWith runs recruitment and study delivery for funded research.

Remote recruitment through IM1-connected GP systems, remote site activation, eConsent, a patient app with built-in patient support, and near-real-time dashboards, all on one governed platform. Platform costs only apply if your study is funded.

Get in touch

Book a discovery call →

✓ Data management plan wording

✓ A letter of support for your application

✓ A costed proposal for your study